Page 1 of 1

Started getting in parts for my brew system

PostPosted: Fri Dec 19, 2008 9:54 am
by thebuddrik
I guess I will need a burner so...
Image

and for an imerstion chiller...

Image

notice my tapemeasure on top of it for scale.


I wish :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol:

PostPosted: Fri Dec 19, 2008 11:45 am
by aleguy
copper has better heat transfer than stainless anyway. BTW I think that burner may be a little large unless you're planning on full-barrel batches.

PostPosted: Sat Dec 20, 2008 10:29 am
by redtail28
I know those multi jet burners and nice but please make
sure you get a propane burner not natural gas.
I have two burner i think one is natural gas and doesnt work
I can change the jets at 2.50 each I dont think so.