Page 1 of 1

Co2 manifold

PostPosted: Mon Dec 01, 2008 1:21 pm
by redtail28
Does anyone have a parts list on making a manifold
to pressure up more than one keg?

PostPosted: Tue Dec 02, 2008 1:27 pm
by aleguy
I think it depends on whether you're using flare connectors or not. Zeeboz built one for Gulf Brew, I would PM him and ask.

PostPosted: Tue Dec 02, 2008 3:03 pm
by Mob_Barley
2-IN-1 AIR MANIFOLD

Image

Supply two air tools from the same outlet.

* 1/4''-18 NPT threads
* Anodized aluminum
* 200 PSI maximum

$1.99 from Harbor Freight online: http://www.harborfreight.com/cpi/ctaf/D ... mber=93979
Just purchase two 1/4" shut-off valves with integrated check valve from just about anyone online. You can even connect two of these babies with a 1/4" x close nipple and have a 4 valve manifold. You can configure the manifolds inline, or at 90 degrees. I bought some of these but haven't got around to making mine yet.

PostPosted: Wed Dec 03, 2008 11:06 am
by aleguy
Interesting idea, but I think Redtail is looking to supply more than two kegs in his kegerator. Most of the parts he will need are available at any good plumbing supply. Personally I'd go with flare connectors and use check valves downstream of the individual shutoff valves. everything else though should be easily obtained locally.